Somchai Wongwises


Ontology type: schema:Person     


Person Info

NAME

Somchai

SURNAME

Wongwises

Publications in SciGraph latest 50 shown

  • 2019-04 Journals Can Persuade Authors to Learn Publishing’s Ethics in SCIENCE AND ENGINEERING ETHICS
  • 2019-01 Prediction of hydrothermal behavior of a non-Newtonian nanofluid in a square channel by modeling of thermophysical properties using neural network in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2019-01 Optimization and sensitivity analysis of magneto-hydrodynamic natural convection nanofluid flow inside a square enclosure using response surface methodology in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2019-01 Numerical evaluation on thermal–hydraulic characteristics of dilute heat-dissipating nanofluids flow in microchannels in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2018-12 Softness Induced Enhancement in Net Throughput of Non-Linear Bio-Fluids in Nanofluidic Channel under EDL Phenomenon in SCIENTIFIC REPORTS
  • 2018-11 A comparison of the thermal and hydraulic performances between miniature pin fin heat sink and microchannel heat sink with zigzag flow channel together with using nanofluids in HEAT AND MASS TRANSFER
  • 2018-03-12 Fast Review Process in Established Journals is Not a Flaw in SCIENCE AND ENGINEERING ETHICS
  • 2018-03 A model of energy management analysis, case study of a sugar factory in Turkey in SĀDHANĀ
  • 2018-02 An experimental investigation devoted to determine heat transfer characteristics in a radiant ceiling heating system in HEAT AND MASS TRANSFER
  • 2017-12 Modeling and optimization of thermal conductivity and viscosity of MnFe2O4 nanofluid under magnetic field using an ANN in SCIENTIFIC REPORTS
  • 2017-02 Numerical study of laminar-forced convection of Al2O3-water nanofluids between two parallel plates in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2016-12 Fundamental basis and implementation of shell and tube heat exchanger project design: condenser and evaporator study in HEAT AND MASS TRANSFER
  • 2016-12 Some Review Journals Do Not Allow Students to Author Reviews: Is this Ethical? in SCIENCE AND ENGINEERING ETHICS
  • 2016-11 Second law analysis of a nanofluid-based solar collector using experimental data in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2016-05 A Study of Calcination Conditions for Synthesizing Fine Particles of (Nd0.33Eu0.33Gd0.33)Ba2Cu3Oy and (Nd0.33Eu0.33Gd0.33)2BaCuO5 in JOURNAL OF SUPERCONDUCTIVITY AND NOVEL MAGNETISM
  • 2016-04 A survey of using multiple affiliations by scholars in scientific articles in SCIENTOMETRICS
  • 2016-04 Sympathy and Emotions in Academic Research Society in SCIENCE AND ENGINEERING ETHICS
  • 2016-02 Effect of volume concentration and temperature on viscosity and surface tension of graphene–water nanofluid for heat transfer applications in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2015-12 Mandatory and Self-citation; Types, Reasons, Their Benefits and Disadvantages in SCIENCE AND ENGINEERING ETHICS
  • 2015-12 Fame bias in editorial choice: Yes or No? in SCIENTOMETRICS
  • 2015-08 Fake Journals: Their Features and Some Viable Ways to Distinguishing Them in SCIENCE AND ENGINEERING ETHICS
  • 2015-04 Is it Ethical for Journals to Request Self-citation? in SCIENCE AND ENGINEERING ETHICS
  • 2015-03 An experimental study on the effect of diameter on thermal conductivity and dynamic viscosity of Fe/water nanofluids in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2014-10 Thermal conductivity modeling of MgO/EG nanofluids using experimental data and artificial neural network in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2014-08 Thermal conductivity of Al2O3/water nanofluids in JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY
  • 2014-04 Prediction of heat transfer coefficients and friction factors for evaporation of R-134a flowing inside corrugated tubes in HEAT AND MASS TRANSFER
  • 2014-02 Neural Network Based Analyses for the Determination of Evaporation Heat Transfer Characteristics During Downward Flow of R134a Inside a Vertical Smooth and Corrugated Tube in ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING
  • 2014-02 Selection of the most suitable refrigerant for a shell and tube condenser in HEAT AND MASS TRANSFER
  • 2013-12 Dispersion of ZnO Nanoparticles in a Mixture of Ethylene Glycol–Water, Exploration of Temperature-Dependent Density, and Sensitivity Analysis in JOURNAL OF CLUSTER SCIENCE
  • 2013-07 Parametric study and optimization of a food can corrugation design using a response surface method in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2013-06 An Experimental Investigation of the Reynolds Analogy and its Modifications Applied to Annular Condensation Laminar Flow of R134a in a Vertical Tube in ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING
  • 2013-05 Fundamental Basis and Application of Cold-Room Project Design: A Turkish Case Study in ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING
  • 2012-07 Simulations of Seasonal Current Circulations and Its Variabilities Forced by Runoff from Freshwater in the Gulf of Thailand in ARABIAN JOURNAL FOR SCIENCE AND ENGINEERING
  • 2012-01 Effect of void fraction and friction factor models on the prediction of pressure drop of R134a during downward condensation in a vertical tube in HEAT AND MASS TRANSFER
  • 2011-10 Performance characteristics of HFC-134a and HFC-410A refrigeration system using a short-tube orifice as an expansion device in HEAT AND MASS TRANSFER
  • 2011-10 Investigation of empirical correlations on the determination of condensation heat transfer characteristics during downward annular flow of R134a inside a vertical smooth tube using artificial intelligence algorithms in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2011-06 Evaporation heat transfer and flow characteristics of R-134a flowing through internally grooved tubes in HEAT AND MASS TRANSFER
  • 2010-09 Numerical investigation of an axi-symmetric laminar jet impinging on a dimpled surface under uniform heat flux using a finite element method in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2009-08 Erratum to “Predicting performance of radial flow type impeller of centrifugal pump using CFD” [JMST 23 (2009) 1620–1627] in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2009-06 Predicting performance of radial flow type impeller of centrifugal pump using CFD in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2009-02 Heat transfer characteristics of a new helically coiled crimped spiral finned tube heat exchanger in HEAT AND MASS TRANSFER
  • 2008-05 Simulation of seasonal circulations and thermohaline variabilities in the Gulf of Thailand in ADVANCES IN ATMOSPHERIC SCIENCES
  • 2007-12 A comparison of the effect of the electrohydrodynamic technique on the condensation heat transfer of HFC-134a inside smooth and micro-fin tubes in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2007-07 Effect of EHD on heat transfer enhancement during two-phase condensation of R-134a at high mass flux in a horizontal smooth tube in HEAT AND MASS TRANSFER
  • 2006-02 Thermal performance of a spirally coiled finned tube heat exchanger under wet-Surface conditions in JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY
  • 2005-06 A tube-by-tube reduction method for simultaneous heat and mass transfer characteristics for plain fin-and-tube heat exchangers in dehumidifying conditions in HEAT AND MASS TRANSFER
  • 2005-05 Effect of fin pattern on the air-side performance of herringbone wavy fin-and-tube heat exchangers in HEAT AND MASS TRANSFER
  • 2004-12 Effect of fin thickness on air-side performance of herringbone wavy fin-and-tube heat exchangers in HEAT AND MASS TRANSFER
  • 2004-06 Heat transfer and two-phase flow characteristics of refrigerants flowing under varied heat flux in a double-pipe evaporator in HEAT AND MASS TRANSFER
  • 2004-05 Performance of smooth and micro-fin tubes in high mass flux region of R-134a during evaporation in HEAT AND MASS TRANSFER
  • JSON-LD is the canonical representation for SciGraph data.

    TIP: You can open this SciGraph record using an external JSON-LD service: JSON-LD Playground Google SDTT

    [
      {
        "@context": "https://springernature.github.io/scigraph/jsonld/sgcontext.json", 
        "affiliation": [
          {
            "affiliation": {
              "id": "https://www.grid.ac/institutes/grid.412151.2", 
              "type": "Organization"
            }, 
            "isCurrent": true, 
            "type": "OrganizationRole"
          }
        ], 
        "familyName": "Wongwises", 
        "givenName": "Somchai", 
        "id": "sg:person.012267021412.00", 
        "sameAs": [
          "https://app.dimensions.ai/discover/publication?and_facet_researcher=ur.012267021412.00"
        ], 
        "sdDataset": "persons", 
        "sdDatePublished": "2019-03-07T14:09", 
        "sdLicense": "https://scigraph.springernature.com/explorer/license/", 
        "sdPublisher": {
          "name": "Springer Nature - SN SciGraph project", 
          "type": "Organization"
        }, 
        "sdSource": "s3://com-uberresearch-data-dimensions-researchers-20181010/20181011/dim_researchers/base/researchers_1923.json", 
        "type": "Person"
      }
    ]
     

    Download the RDF metadata as:  json-ld nt turtle xml License info

    HOW TO GET THIS DATA PROGRAMMATICALLY:

    JSON-LD is a popular format for linked data which is fully compatible with JSON.

    curl -H 'Accept: application/ld+json' 'https://scigraph.springernature.com/person.012267021412.00'

    N-Triples is a line-based linked data format ideal for batch operations.

    curl -H 'Accept: application/n-triples' 'https://scigraph.springernature.com/person.012267021412.00'

    Turtle is a human-readable linked data format.

    curl -H 'Accept: text/turtle' 'https://scigraph.springernature.com/person.012267021412.00'

    RDF/XML is a standard XML format for linked data.

    curl -H 'Accept: application/rdf+xml' 'https://scigraph.springernature.com/person.012267021412.00'


     




    Preview window. Press ESC to close (or click here)


    ...